Titanium anodizing jig rack and Titanium dished disk features
Features:
1, good electrical conductivity, acid resistant titanium material manufacturing. The contact part with the conductive rod is made of the best copper hook.
2, can make the current freely through. It will not burn off the titanium jigs/racks because the section is too small and the electric negative is too large.
3. The contact area between the titanium anodzizing jig/rack and the parts is small, but the current is guaranteed. Contact points do not generate local overheating, burn parts or fixtures.
4, Thickness below 0.6 mm sheet or molding parts, high dimensional accuracy and roughness of parts, hard anodic oxidation of parts, hanging from a gm can't hang parts, in order to guarantee product quality and improve the efficiency of production, according to the appearance of parts and anodic oxidation of parts design and manufacture of special anodzing titanium jigs/racks, to ensure the quality of parts anodic oxidation.
Precautions for the installation and use of titanium oxide hanging device and titanium disk:
1. The distance between the bottom of the titanium jigs/racks and the bottom of the groove is 150~200mm
2. The working concentration of the electric parts is about 40~60mm away from the liquid level
3. The distance between the titanium jigs and the hanger surface is 20~40mm
4. The hanging device and groove wall should be greater than 50mm
5. The loading quality of titanium racksthat can be used for manual operation is generally about 1~3KG
6. The position of the lever should be more than 80mm from the liquid level to bear the mechanical strength of the whole jig and working weight 7, the main bar and the support bar should bear the weight of the camel's work and the role of the transfer of current should be sufficient mechanical strength and conductive intercept
8. Can be customized according to customer needs titanium hanging tools, such as titanium disc, titanium screws
