Nov 15, 2021 Leave a message

The Influence of extrusion heating process on titanium pipe

The Influence of extrusion heating process on titanium pipe fittings


According to the characteristics of titanium alloy, some scholars used extrusion method to produce TA15 hot working pipe, and studied the effects of extrusion heating temperature, annealing system and extrusion ratio on the microstructure and properties of extruded titanium pipe.


1.Process route and method:

The process route is: titanium rod → preparation of ingot → cladding → extrusion → straightening → pickling → annealing → machining → inspection → sampling.


2.Effect of annealing system on Microstructure and properties of pipes:

The effect of Annealing on the microstructure and properties of pipes was studied when the extrusion temperature was 950 ℃ and the extrusion ratio was 10.2.


1. Effects of annealing temperature and annealing holding time on Microstructure and properties of pipes:

The results show that increasing the annealing temperature has little effect on the properties of extruded pipes; The delayed annealing time will make the recovery and recrystallization more complete, and the result is that the strength of the alloy is reduced and the plasticity is improved; The annealing time of TA15 titanium alloy has little effect on the microstructure and properties. Therefore, according to the comprehensive properties and metallographic structure characteristics required by the pipe development, the extruded pipe blank is extruded at 950 ℃, the extrusion ratio is 10.2, the extruded pipe is subjected to 800 ~ 850 ℃, 1 ~ 2H, AC annealing, and the main purpose of annealing is to eliminate the internal stress formed by processing hardening in the process of hot extrusion through recovery and recrystallization.


2. Effect of cooling rate on mechanical properties and microstructure of pipes:

The results show that the mechanical properties of air cooling pipes are stable and reasonable. The cooling of extruded pipes after annealing is air cooling: from the perspective of microstructure and properties, due to the uneven microstructure in the process of hot extrusion, dynamic recrystallization occurs in the process of hot extrusion. The smaller cooling rate after hot extrusion makes the density of structural defects in the alloy relatively low, and the subsequent annealing has no great impact on its properties. And because when squeezed in the two-phase region, α Phase harmony β The grains are flattened and elongated along the deformation direction. At 700 ℃, the microstructure basically retains the hot extrusion structure, and there are a large number of primary particles in the metallographic structure at 800 ℃ α The phase and structure are basically spheroidized equiaxed a + intergranular β Due to the slow use of air cooling, β Relatively fully transformed into α Phase, recrystallization has been carried out at 850 ℃, and the obtained structure is a+ β Phase, and newborn α At the same time, the grains are refined. Considering the mechanical properties and microstructure of extruded pipe, it is considered that TA15 pipe is annealed at 800 ~ 850 ℃ for 1 ~ 2H in AC, which is conducive to further pressure machining of titanium pipe. Therefore, the process conditions are more reasonable.

201711296


Send Inquiry

whatsapp

Phone

E-mail

Inquiry